1500A Split Core Hall Effect Current Sensor GB/T 25119

1. When the measured current direction is consistent with the direction marked on the sensor, the sensor output ISN is positive.

2. The secondary side connection line of the product is preferably a shielded line, and the shielding layer is close to the product end and the connection line can be connected to the case, and the negative power supply or power supply 0V.

3. The verticality requirement of the mounting screw hole of the power sensor: it must be level 8 or above in the national standard (or below 0.06).

4. Flatness requirements for the installation surface of the power sensor:

(a). The flatness of the large plane installation is level 11 or above in the national standard (or the plane fluctuation is less than 0.25mm);

(b). When the installation surface is designed with a small round boss, the flatness shall be level 12 or above in the national standard (or the plane fluctuation is less than 0.5mm);

5. No tolerance ±0.5mm;