24V100AH Rechargeable Lithium Battery Pack Light Weight , Lifepo4 Battery Pack Fast Charge

• long life & deep cycle( over 2000cycles @ 100%DOD)
• with built-in PCM/BMS protection
• super quick charge/discharge performance
• safe pressure valve design ( no explosion, no fire)
• high energy density
• low self-discharge( <3% per month,<15% per year)

1. General Information

This specification defines the performance of rechargeable LiFePO4 battery pack describes the type, performance, technical characteristics, warning and caution of the battery pack.

2.

Specification

Customize Any of The Following Battery Packs as Required
Can be customized according to the requirements of 3.7V, 7.4V, 11.1V, 14.8V, 18.5V, 22.2V, 25.9V, 36V, 48V, 60V, 72V

BMS specification of 200Ah lithium battery 24 volts rechargeable​:
Cell overcharge detection voltage: 3.90V±50mV
Cell overcharge recovery voltage: 3.80V±100mV
Cell over-discharge recovery voltage: 2.30V±100mV
Rated operational charge current: 200 A
Over current detection: 100±30A
BMS impedance: ≤20mΩ

Product advantage

a. Life 2000 cycles, more than 85%.

b. Large overcharge tolerance and safer performance.

c. Self balance.

d. Four times higher energy density than Lead-acid battery.

e. Light weight and smaller than Lead-acid battery.

f. High temperature performance.

g. Low self discharge

3.

Electrical Characteristics & Test Condition.

@Ambient Temperature 25±5℃ & Humidity 45%~75%.

Safety Test

No fire, no explosion

Charing to 3.7v and do nail penetration test, there is no fire, no explosion, no any other obvious changes.

Nail Penetration Test and Overcharge Test

After testing, no fire and no explosion, that is definitely approved than our lithium batteries deserve you.

BATTERY PACK SAFETY TEST

4.1 Testing condition (Unless Special Requirements)

Temperature:20±5℃ Relative Humidity: 45~75%

Atmosphere Pressure: 86~106kPa

All testing under full capacity

4.2 Battery Pack Safety Test

4.

Circuit Protection

The batteries are supplied with a LiFePO4 Battery Management System (BMS)that can monitor and optimized each single prismatic cell during charge & discharge, to protect the battery pack overcharge, over discharge, short circuit. Overall, the BMS helps to ensure safe and accurate running.

Applications

· Energy Storage Systems (ESS)

· Remote area power systems

· Communications systems

· Electric vehicles

· Marine environments

· Military & Aviation

· Industrial Machinery

· Uninterruptible Power Supplies

· CCTV & Data Transfer

Warranty

• We offer 3 years warranty for battery packs in low discharge rate (below 1C) applications,
• We offer 2 years warranty for battery packs in high discharge rate (1~3C) applications.
• For charger / BMS, here are one year warranty.

Store

◆For long time storage ,the battery should be charged to Approx 60% SOC ,its corresponding voltage should be 1.05times of nominal voltage(24V,36V,60Vor72V),usually it's voltage in shipment .The battery should be kept in storage in dry and ventilated place.

◆ The battery pack and charger should be stored in clean, dry and ventilated place, avoid contacting with corrosive materials and be away from fire and heat.

Quality Control

We do below test before delivering

Capacity test, High current discharge test,Low temperature test, Short circuit test, Over charging test,

Over discharging test, Cycle performance test, Crush test, Impact test, Vibration test, High temperature test

Our Services

1. Special packaging design--We can provide packaging design services according to customers' guidance and experience, including Print the design of inner box and carton. no need to worry about design because we have professional designers working in our factory.
2. Within the warranty period, any defective products will be repaired or replaced free of charge.
3. Can design various sizes, capacity and logo customized.
4. Professional after-sales service system, When the batteries or BMS are broken during the warranty period, we provide a replacement.

FAQ

1. What's your advantage?

Small order is acceptable, zero risk, quality assurance.

2. Can you accept OEM and ODM services?
Yes, just tell me your requirements and we will provide you with the best solution.

3. What are your payment channels?
TT, L/C, West Union etc.

4. What service do you provide?
All our batteries have passed the safe test and performance test before shipment.
Support printing your logo on the battery.
Small order is acceptable.

5. Is your lithium battery reliable?
Yes. Overcharged, over-discharged, nail penetration test, all protected by our battery.

6. Can I get a lower price if I order large quantities?

Yes, very competitive prices with more quantity.

7. How you shipping the goods and how long it will take?
Normally FEDEX, DHL,UPS etc, around 4-7 days.

8. Can I just try samples for the first order?

Yes, 1 pcs sample and small trial order are acceptable.

24 hours customer service, waiting for your inquiry!